Xbox 360 3 Red Lights Guide And Xbox Fix Bonus
Are you tired of dealing with the Ring of Death error? It’s time that you rocked your own copy of the Xbox 360 Red Light Fix. This James Dean Xbox 360 Guide will walk you through simple and effective fixes for the most common Xbox 360 errors.
This Xbox 360 fix will show you how you can deal with the most common Xbox 360 problems, like the three red light errors, with very everyday household tools. You don’t need any special or technical knowledge.
The repair guide has a set of professionally produced high definition videos that will show you exactly how to fix the kind of error your console has encountered.
After thinking about the money and time it would take to get Microsoft to repair it, I figured why not! Bring on the guide!
If you’ve got blinking red lights on your Xbox 360, have no worries it’s something that can be easily fixed.
Why do Xbox 360 problems happen? That’s a question that’s been asked by millions of people, so you are not alone!
James has comprehensively explained how to fix the three red lights. James promises to have you up and playing your Xbox 360 within one hour and he doesn’t disappoint.
Tired of the xbox 360 3 red lights error? or Xbox 360 Red Ring of Death Error? Xbox 360 E74 Error? The solution to such problems can be very expensive if you decided to use Microsoft support, even if you still have your warranty you still have to pay for the shipping.
Download James Dean’s 3 Red Light Fix Guide and Fix your Xbox 360 Right NOW!!
The first XClamp Repair video demonstrates the process of removing the heat sink from the motherboard, cleaning, and then reattaching them. The second XClamp video shows a similar demonstration of how the removal and reattachment of the heat sink can be done in around four minutes. Once again these are both unspoken.
The ‘Getting Started’ section is clearly defined and following the directions you can go to the videos. You won’t feel lost in the member’s area when you are there.
And then there are the multitudes of YouTube videos claiming to have found the miracle fix. Here are some that seem to be most popular – and ridiculous:
* The Towel Trick – It goes something like this: You take the hard drive off, wrap the entire unit in a towel to prevent the excess heat from escaping, turn the console on for about 15 minutes to cook (some instructions recommend 1 hour!), shut it down, unplug it for an hour, plug it back in and like magic it works. But why? I haven’t heard a decent explanation yet. Here is one of the explanations:
* The unit gets so hot that it melts the solder that was the cause the red lights in the first place.
Here are a couple of potential hazards as pointed out in the same video:
* Could potentially damage other parts of the Xbox; and
* The unit could catch on fire it gets so hot.
I have to say I am going to rate this as the 2nd most ridiculous fix of the three in consideration. Recommendation: Do not use this fix!
* The Ice Bath – I don’t even want to explain how to do this. Essentially, a Rubbermaid tub is filled with ice water, some vinegar is added, the Xbox 360 is unplugged and submerged in the water/vinegar mixture. After so many minutes the console is removed, drained of water and immediately plugged back in. Need I say more. I actually heard of a kid who attempted this and was severely shocked. This fix is the most ridiculous fix of the three in consideration. My recommendation: Ignore!
* X-Clamp Fix – This is the only legitimate fix I have found thus far. It is as permanent as it gets. Do not use it however if your Xbox 360 is still under warranty. Send the console back to Microsoft and let them honor the warranty. However, if the seal is broken and/or it isn’t under warranty this fix is your best bet. This is the fix in a nutshell; you open up the console, remove the x-clamps, clean up the old thermal paste, put new thermal paste on, replace the x-clamps with screws and washers, reassemble the unit, overheat, let it cool down and it works on approximately 90% of the units. Recommendation: Use this fix.
Before we start, we must understand – What Causes the Xbox 360’s Red Ring of Death? The Red ring of death is a sign of “general hardware failure”. It is indicated by 3 red lights or 3 red rings near power button. It occurs when the GPU (graphics processing unit) becomes loose. Because the GPU is actually on motherboard, when ever the mother board heats up, the may become GPU loose. A loose GPU causes the green power light to turn into 3 flashing red lights. In addition, the constant heating and cooling of the machine caused by turning the machine on and off before and after game play, can cause the solder joints of the GPU to fail. This will freeze up your xbox 360.
Here’s some of the steps needed to fix the red ring of death error:
* Disassemble Xbox 360 Case – Using a fine tip screwdriver, poke the grayed out holes in the back of the case (poke the small rectangle holes). Get the Faceplate Off and move the latch up on the DVD drive up as you remove it. Unscrew the metal case which is under the plastic case. The video ‘How to Disassemble Xbox 360 Case’ which comes with James Dean’s Professional Xbox 360 repair guide is easy to follow and to the point. If you are not too comfortable with the ebook instruction, you can use this video to disassemble your Xbox 360 case;
* Remove the Motherboard – Unplug any cables connected to the motherboard and associated small devices;
* Take your take DVD drive out;
* Get the fan and motherboard out of the case. Do this gently 
;
* Motherboard Disassembly – Turn the motherboard over and using a screwdriver, remove the X-clamp under heat sink. Do this step VERY gently (If you are not comfortable doing this, refer to the video which comes with James Dean’s 360 repair guide.);
* Applying Arctic Silver – Now you have to apply some arctic silver thermal compound gently over the GPU. You can get arctic silver thermal compound in any computer hardware shop for a couple of bucks. Set it aside for 15 to 20 minutes then place 2 nylon washers on each screw on the heat sink. Place the screws back in the motherboard and add two more nylon washers to screws. Place the heat sink on the tip of the screws and push them down gently. Finally, tighten the screws (not too tight!). Get everything back together, making sure everything is fitted properly. Now, turn your Xbox 360 back on and have some fun.
Start gaming already – Fix your Xbox red ring of death easily! Don’t pay 0 plus shipping for something that virtually anyone can do in under 2 hours.
You can learn more about the Red Ring of Death and many of the other common Xbox 360 errors by visiting xbox 360 fix. There’s also a great deal on the 3 red light fix guide. Last but not least, you can grab a $120 bonus for the xbox 360 3 red lights at fixurxbox.com.